ASME / ANSI standards for piping - List of standards from ASME (American Society of Mechanical Engineers) and ANSI (American National Standards Institute) for piping.
ASME (American Society of Mechanical Engineers) Standards
You may also like
Single Seal or Double Seal ?
The decision to use double mechanical seal instead of single mechanical seal is not easy. Many parameters influence this decision...
Clean agents are generally divided into two (2) groups: halocarbon agents and inert gases (IG).
A typical table of the clean agents covered by NFPA is...
B16.1 (2005) - Gray Iron Pipe Flanges and Flanged Fittings: Classes 25, 125, and 250
This Standard covers Classes 25, 125, and 250 Gray Iron Pipe Flanges and...
Before the advent of the ATEX Directives, the installation of electrical equipment in a potentially explosive area was a matter of just selecting equipment...
Fire hazards normally protected by water spray systems
Water spray protection for fire fighting is acceptable for following categories of fire hazards:
...